Tools
!
TCRZ
Weight: g

Bullet Crimping Tool

With this tool You can crimp Your own Bullet-Terminals and give them an appereance as it would have been done in the factory.
This tool have a ratchet which is active until the designed pressure is achieved. If the tool have to be opened earlier, there is a 'emergency opening' available which can be handeled with one hand.
TCLZ
Weight: g

Closing tool

This tool helps You to fit the bullet-terminals propperly into the connectors
usually these terminals ara just fumbled into the connectors. This may result in a bad fitting of the terminals in the connectors wich in turn causes again some electrical problems even when the cabeling is just done.
This tool picks up the problem where the cable just enters the terminal. Just squeese the pliers with feeling and then the terminals will snap into place perfectly.